Made in the USA  .... Comes with four 8-40 torx head mounting screws, eight torx head cap screws and L shaped torx head wrench. 

34mm not available in Low or in extended version

Extended front ring version - brings the front ring closer to the rear ring by 1/4" to allow mounting for scopes with shorter tubes.  Front extended ring can be reversed for the opposite effect however,  that is not the common way to use this ring.

Front mount height as measured from the closest contact point at the receiver to the bottom of the ring cradle

Low .400", Medium .500", High .600"

Finishes: Black Anodized or silver bead blasted finish

TALLEY LIGHTWEIGHT ALLOY SCOPE MOUNTS
The one-piece construction of the Talley Lightweight Alloy Scope Mount is unique. The rigid design has no joint between the scope and the rifle. The Talley Lightweight unitized design eliminates the possibility of an “out of alignment” interface or “loose connection” between the ring and base of traditional two-piece designs.
Ultimately this provides more strength and durability than rival steel rings and bases but doing it with a lighter overall weight.

By extruding the 7000 series alloy known for its durability and then precision CNC machining the mount to its final design we can provide you with the strongest, lightest mount system on the market.

Height:

Low: Front .400″ Rear .510″ Available in 1″ & 30mm

Med: Front .500″ Rear .610″ Available in 1″, 30mm, & 34mm

High: Front .600″ Rear .710″ Available in 1″, 30mm, & 34mm